The following is a list of scientific papers, technical journals, periodicals, and conference publications which reference the use of OptiGrating. These references were collected from internal sources, customer submitted papers, and scientific articles via Google Scholar – and to the best of our knowledge, make use of our OptiGrating software package. If you locate any mistakes, please notify us immediately by contacting info@optiwave.com.
[1]
Z. Xiaohang and W. U. Xiangnong, “A Hybrid Design of Temperature-Strain Dual-Parameter Sensing Based on Sampled Optical Fiber Grating,” 2017 Conference on Lasers and Electro-Optics Pacific Rim (CLEO-PR), vol. 16, no. 15, p. 1430400, 2017.
[2]
M. K. Mathew, R. G. J. Valooran, and N. K. Vaegae, “An effective temperature monitoring scheme using ANN-based fiber Bragg grating sensor,” International Journal of Intelligent Engineering and Systems, vol. 10, no. 4, 2017.
[3]
P. Stopniak and P. Kisa\la, “Analysis of impact long period Bragg gratings parameters on their spectral transmission characteristics,” Proceedings of SPIE – The International Society for Optical Engineering, vol. 10445, 2017.
[4]
A. T. J., N. Kachare, K. Kalyani bai, and D. S. Kumar, “Analysis of simultaneous measurement of temperature and strain using different combinations of FBG,” AIP Conference Proceedings, vol. 020031, p. 020031, 2017.
[5]
G. Palai, “Computation of impurity concentration in silicon photodiode based on their optical properties,” Optik, vol. 133, pp. 108–113, 2017.
[6]
P. Mishra, K. C. Bhuyan, and H. K. Sethi, “Development of FBG Sensors using Optiwave system software for structural health monitoring,” International Journal of Engineering Science Invention.
[7]
A. Czapla, W. J. Bock, T. R. Woliński, P. Mikulic, R. D\c abrowski, and E. Nowinowski-Kruszelnicki, “Electrically tunable long-period fiber gratings with low-birefringence liquid crystal near the turn-around point,” Opto-electronics Review, vol. 25, no. 4, pp. 290–295, 2017.
[8]
J. Habel, T. Boilard, J. S. Frenière, F. Trépanier, and M. Bernier, “Femtosecond FBG written through the coating for sensing applications,” Sensors (Switzerland), vol. 17, no. 11, 2017.
[9]
R. L. Rito, A. D. Crocombe, and S. L. Ogin, “Health monitoring of composite patch repairs using CFBG sensors: Experimental study and numerical modelling,” Composites Part A: Applied Science and Manufacturing, vol. 100, pp. 255–268, 2017.
[10]
M. M. Elgaud, M. S. D. Zan, A. G. Abushagur, and A. A. A. Bakar, “Improvement of signal to noise ratio of time domain mutliplexing fiber Bragg grating sensor network with Golay complementary codes,” Optical Fiber Technology, vol. 36, pp. 447–453, 2017.
[11]
K. M. Salas-Alcántara et al., “Modal interferometer based on a single mechanically induced long-period fiber grating and a nanoparticles-coated film section,” Optics Letters, vol. 42, no. 9, 2017.
[12]
B. Ghosh and S. Mandal, “Modeling and Performance Analysis of Bragg Grating in Z-domain,” IEEE Photonics Technology Letters, pp. 1–1, 2017.
[13]
O. O. Olowo and A. Abdulkareem, “Modelling and Analysis of Powerline Temperature Surveillance with Optisystem Simulation,” The International Journal of Engineering and Science (IJES), vol. 6, no. 8, 2017.
[14]
F. S. Delgado and A. B. dos Santos, “Multi-measurement scheme for a fiber-optic sensor based on a single long-period grating,” Journal of Modern Optics, vol. 64, no. 21, pp. 2428–2432, 2017.
[15]
M. Śmietana, P. Mikulic, and W. J. Bock, “Nano-coated long-period gratings for detection of sub-nanometric changes in thin-film thickness,” Sensors and Actuators, A: Physical, vol. 270, pp. 79–83, 2018.
[16]
T. Mizunami, R. Shioya, and M. Minami, “Offset-launch measurement for few-mode long-period fiber gratings fabricated using tilted amplitude mask,” 22nd Microoptics Conference (MOC), 2017.
[17]
C. Fahd, A. Otman, and E. L. Y. Mounir, “Performance Investigation and Enhancement of Fiber Bragg Gratingfor Efficient Sensing Measurement,” IOSR Journal of Electronics and Communication Engineering (IOSR-JECE), vol. 12, no. 2, 2017.
[18]
W. S. Al-younis and M. H. Bataineh, “Pulse Compression Using Fiber Bragg Gratings,” 4th International Conference on Electrical and Electronic Engineering (ICEEE), pp. 240–245, 2017.
[19]
S. Chunsheng, Z. Jiaxiang, Y. Mo, S. Erwei, and Z. Jinguang, “Reconstruction of fiber Bragg grating strain profile used to monitor the stiffness degradation of the adhesive layer in carbon fiber-reinforced plastic single-lap joint,” Advances in Mechanical Engineering, vol. 9, no. 3, 2017.
[20]
P. Tao and X. Wu, “Study on sensing characteristics of phase shifted fiber grating,” 16th International Conference on Optical Communications and Networks (ICOCN), 2017.
[21]
T. Wang, K. Liu, J. Jiang, M. Xue, P. Chang, and T. Liu, “Temperature-insensitive refractive index sensor based on tilted moiré FBG with high resolution,” Optics Express, vol. 25, no. 13, p. 14900, 2017.