Base
Full Name | Jawaher Alshehri |
Organization | pnu |
Job Title | student |
Country |
Forum Replies Created
الف شكرا يا فراس .. الحمدلله ضبطت معي .. يعطيك العافيه
أهلا فراس ,,
ايوه عرفت البرامج الخاصه بعمل الفيديو لكن بالنسبة للرسم .. الخ ماهي راضيه تضبط معي مو عارفه ليش .. مجرد ما ارسم المربع بتطلع لي كذا
ماني عارفه كيف أخلي الـ Channel
اللي عملتها تطلع فوق المربع
…
Attachments:
OK thank you Alessandro ,,
Thank you so much AliStu & Feras for feedback ..
Kindly if you are enable to give some detailed information or references about what is the meaning Q-factor , Min BER , Threshold and BER pattern ?
Finally i can see the BER Q-Factor … etc expect the BEAR pattern not see
Is it normal or error??
Attachments:
I create new project still can’t show BER analyzer 🙁
Attachments:
OK , but how can i find it in optisystem as a chose .
OK I know to create DCF .. thank you
but how can i see the value of channel spacing because i want to edit it .
BER still like pic 2 i don’t find the shape in pic 3
look at the blue arrow
Attachments:
I have question how can i find DCP component , i can not find it
also BER Test set it’s not the same in optisystem program
in optisystem show BER like pic2
Attachments:
This is requirement for our project :
• The data rate is 3.85*10^11 bit/sec.
• The cable length is 434.5 Km.
• The link type is full duplex single mode step index fiber.
• The amplifier spacing for every 96 Km.
• The wavelength window is 1500 – 1600 nm.
• The operating wavelength is 1550.
we should to design 16 channel between tow cities and the Total distance between the cities = 434.5
I will try to change & Tomorrow i will tell you what happened with me …
Thank you so much
thank you Alistu
this is my project file