Forum Replies Created

    #24018
    Profile Photo

    the osd file as attached

    Attachments:
    #23611
    Profile Photo

    Dear Damian,
    I changed the sequence length from 164 bits to 256, buy there is no change in results in both versions.

    #23419
    Profile Photo

    Sorry the attached file missing

    Attachments:
    #23414
    Profile Photo

    yes, alistu. I understood what you mean. Also i wondered, but it is happened with me.

    #23409
    Profile Photo

    Thank you sam sung.
    Thank you alistu.
    I found the problem that i ran system established by optiwave v.7 in optiwave v.13, but when i established the same system by optiwave v.13 component it works fine.

    #23373
    Profile Photo

    Thank you Alistu

    #23369
    Profile Photo

    the attached file for FSO using PIN photo diode,by run the simulation the program is stuck.

    Attachments:
    #23337
    Profile Photo

    Dear All,
    Dear Damain,
    Could you please help me to resolve the error in my simulation that call matlab program to establish negative exp Channel in free space optical communication, as the attached m and osd files.
    Hope your support.
    Regards,
    Ahmed

    Attachments:
    #22491
    Profile Photo

    Gurpreet Kaur, in addition you should observe From eye diagrams, the value of Q factor and Minimum BER are taken up to BER < 10-9 to achieve an error free communication, as this is the limit up to which successful communication can take place.

    #22096
    Profile Photo

    Abhishek Shrama
    kindly find the attached paper, i think it will help you a lot

    #22094
    Profile Photo

    Thank you for Optiwave

    #21756
    Profile Photo

    Thanks Damian, but i can’t open the osd file, could you please send it to me via my my e-mail(ahmed.teama@te.eg)
    yours,

    #21669
    Profile Photo

    May be the program didn’t installed correctly, try to remove it and install again.

    #21667
    Profile Photo

    for example of using co simulate matlab with optisystem you can a look at:

    Matlab Binary Switch

    #21666
    Profile Photo

    Dear Damian,
    Are You find the attachment, kindly i need your advice.
    Thanks