Home › Forums › SYSTEM › Eye Diagram obtained from PON using WDM Mux › Reply To: Eye Diagram obtained from PON using WDM Mux
September 9, 2015 at 12:44 pm
#24506
Hi Shahbaz,
I just used a WDM CW laser in your FILE-21 and it worked well for all users! Here is the figure of its min BER vs transmitted power attached for the first four BER analyzers, along with one for the N1 file. I followed the exact steps depicted at:
As you can see, the results seem acceptable for both even though I did not change bit sequence (I shortened the fiber though to reduce simulation time). But when the power goes up, maybe due to nonlinearities the error increases. So if I hadn’t increased power in sweep mode to that amount, I would have had waterfall-shaped figures. See if these help.
Regards